If during the inspection of the screed under the parquet it turned out that it heats up too much, then there is an urgent need to insulate the heating pipes laid under it. For this, no matter how much you want, it will go completely to raise the flooring, undermine the layer of glue and the basics. All this must be done in order to completely remove all the consequences of an excessively high temperature affecting the parquet. It is worth noting that the quality of heating in the rooms depends not only on the isolation of the pipes, but also on the state of radiators. If the radiators are outdated, then it’s time to buy steel radiators on the site/Catalog/Steel-Radiators.
All of the above must be done without delay, if the floor temperature exceeds fifty degrees and in cases where the surface has a temperature higher than in the room by three to five degrees Celsius. To stop overheating of the flooring pipes, they should be isolated from the base. This can be done using polyurethane foam, which has very large heat -absorbing properties. During work on opening the flooring, there is no need to completely remove the entire parquet. Can be done more and more economically. Using the sensor, you need to find out the places of pipe run and mark them, then you should remove that part of the parquet that passes above the pipes and proceed to remove the screed.
