To change the broken or tied glass in the window frame, it is necessary to gently remove the fragments from the window binding, as well as the remains of the old putty. Do not forget to remove the glazing and extract cloves. Then the frame is cleaned of dirt and dust. After that, the fold of the frame of the frame needs to be primed with whitewood diluted by the Oliphi.
Glass carved to the desired dimensions is installed in place of the broken one and fixed either with hairpins or nails without hats located around the perimeter of the frame at a distance of 300 mm from each other.
Cloves or hairpins should be located parallel to glass, but not tightly pressed against it. With the help of sliding blows, the mounting chisels are clogged into the frame to a depth of up to 3 mm relative to the width of the fold.
After fixing the glass of the hairpin or cloves without hats, they are closed with a special putty, which must be carefully pressed into the fold. In this case, you can use a chisel or knife. The putty around the entire perimeter should lie in an even layer and have the same width.
This version of glazing is called a single insert. There is a glazing method of double putting. First, a half -liquid putty is applied to the folds, on which the glass is laid and tightly pressed to the fold. Excess squeezed putty are cut off, and the glass is fixed with hairpins. Then, along the folds, they are already passing a layer of thick putty.
